Category: Installation and Replacement
Service Tray Troubleshoot and Recovery
The Callisto service tray is a consumable and will periodically need to be replaced. When replacing the service…
Replacing the Output Surface
This video provides instructions for replacing the Output Surface within the Callisto printer. The printer must be…
Replacing the Input Surface
This video provides instructions for replacing the Input Surface within the Callisto printer. The printer must be…
Checking the Callisto Versions and Updating the Software
Checking the Versions The Callisto version information can be viewed through the Operator Panel by selecting the…
Loading Media on the Callisto Large OD Roll-to-Roll System
To load media on the the Callisto Large OK Roll-to-Roll System, follow these steps and view the…
Programming the Callisto Scaler Board
Before completing the steps shown in this video, please schedule an appointment with NeuraLabel Support at support@neuralabel.com….
Installation Procedure: Driver and Network Setup
The following document explains how to properly install the Callisto printer driver and set up the network…
Installation of Callisto WiFi Card
The following video shows instructions for the installation of the optional WiFi Network Card into the Callisto…
Setting up the Callisto Printer
The following video provides instructions for unpacking and setting yo your Callisto Printer. It does not cover…
Repackaging the Callisto Printer
The following video provides instructions for properly repacking the Callisto Printer. The Callisto printer must be packaged…
Webbing the Callisto Winders
The following video provides instructions for webbing up the Callisto printer standard-sized (8.5″ wide) unwinder and rewinder….
Callisto 12-Inch Roll Units Webbing
The following video will provide instructions for loading media into the Callisto 12-Inch wide Roll-to-Roll system. Adjust…